Продвижение / ведение / техподдержка сайтов и контакты админа форума: aceweb.ru Распечатать календарь на Март 2024 года: calendar2008.ru/2024/mart/ |
Форум по ремонту принтеров | Помощь |
Здравствуйте Гость ( Вход | Регистрация ) | Выслать повторно письмо для активации |
Printer0k |
Отправлено: Jul 30 2020, 08:19 AM
|
Сержант Группа: Members Сообщений: 17 Пользователь №: 11558 Регистрация: 4-October 18 |
Доброго времени суток, поступил данный аппарат в ремонт с кодом 2550 а если быть точнее:
Code: C2550 Description: Conveying motor startup error Causes: The conveying motor is not in the steady state within 2s after start-up. Remedy: 1 Firmware upgrade The firmware is not the latest version. Upgrade the engine firmware to the latest version 2 Checking the connection The connector is not connected properly, or the wire is faulty. Clean the terminal of the following wire connectors and reconnect the connectors. If there is no continuity, replace the wire. • Conveying motor - Engine PWB (YC14) 3 Checking the drive unit The drive unit is faulty. Execute U030 [Feed] and check the feed motor operation. If there are any load for the gear rotation inside the drive unit replace drive unit C. 4 Replacing the conveying motor The conveying motor is faulty. Replace the conveying motor. 5 Replacing the engine PWB The engine PWB is faulty. Replace the engine PWB. И первом шаге предлагается обновить ПО но где ее достать я так и не нашел.В SM если я не ошибся это мотор подачи бумаги. Через режим обслуживания пытался запустить мотор но все заблокировано.Стоит ли начать с визуального осмотра узла подачи? |
Владимир А |
Отправлено: Jul 30 2020, 09:19 AM
|
||
Expert Группа: Admin Сообщений: 4481 Пользователь №: 2048 Регистрация: 7-July 09 |
ПО для Кисы надо у официалов просить, позвонив по бесплатному номеру(там спросят серийник, текущую версию, проблему и Ваше мыло, по которому и вышлют ссылку на ПО). -------------------- |
||