, 50.7 50.9 50.1

[Greg]

Rebiata izveniti za translit ....
mojet kto nibud` mne smojet pomo4 reshut` eti problemu:
y menia gdeto 15 fusers ot 3800 , vse doiyt error 50.7/50.9/50.1 est` li sposob ix ispravit`?

[Spiller]

50.7 Fuser Error
Denotes a fault with the fuser drive motor or the fuser motion detection sensor (do not change the fuser)
Remove the fuser and check that it rotates freely. This error can also be caused by a jammed fuser. Remove the cause of the jam if possible, if not replace the fuser.

A 50.9 fuser error is one of the most common errors. If you get a 50.x error, you can try turning the power off and on and reseating the fuser but in almost all cases you will need to replace the fuser.

50.1 Low fuser temperature
50.2 Fuser warm-up error *
50.3 High fuser temperature
50.4 Faulty fuser
50.7 Fuser pressure release mechanism failure
50.8 Low fuser temperature (sub-thermistor)
50.9 High fuser temperature (sub-thermistor), or pressure release mechanism problem

* If you receive a 50.2 error, especially on the CP3505, and it only occurs when printing envelopes, try updating your firmware. Otherwise you'll need to replace the fuser.
50.X Fuser Error
Where x = 1-6
A fuser error has occurred.
Turn the printer off and wait 20 minutes. If the error continues disconnect the printer form the mains and reseat the fuser. Wait 20 minutes before reconnecting power.
If the error continues replace the fuser.
If the problem is not related to the fuser change the engine (ECU) board.

[Greg]

blagadariy many 10x


pls vklui4ite poik tem - ne rabotaet